Electrolux Washer No Water Error Message

Tap closed or water pressure too low.

Electrolux washer no water error message.

Turn the water off and remove the hoses from the back of the washer. Leaks from water circuit on pressure switch. Turn the water on to make sure you have good water pressure from both hot and cold water lines. Tap closed or water pressure too low.

Washer dryer displays error message e30 c3 or emits 3 beeps. The error is caused by water at the bottom or inside the machine. Drain tube improperly dositioned. Water fill solenoid valve is faulty.

If they are clogged flush them out. If everything checks good you just need to replace your electronic water valve because it has failed and isn t letting any water into the washer. Water fill solenoid valve is faulty. You ll need to pull the washer forward and turn the water off to the washer.

If the hoses are good and you haven t found anything slowing down the flow of the water your electronic inlet water valve is just faulty on the back of your washer and will need to be replaced because it s just not allowing water flow into the washer correctly. Check the little filter screens where the fill hoses connect to the back of the washer.